Need a hand setting up or using your system? The new Revel Assistant can guide you through almost anything you'd need to do, step by step. Just head to your Management Console and click the question mark in the bottom right corner to check it out!

Setting a Static WAN IP address on the TP-Link and DD-WRT routers

By Sam

Follow

Note:

While these routers are no longer sold, some customers may still have this equipment. This guide is meant for those older routers that need a Static WAN IP Address.

To begin setting a static WAN IP Address, make sure the client is connected to the router. This can either be by a wireless connection through the Access Point (assuming it is online and broadcasting) or through a direct ethernet connection to one of the TP-Link or DD-WRT Router’s yellow LAN ports.

  1. Open a Web Browser and type the router’s IP address into the Address Bar:   
    192.168.22.1
  2. Once the Router page comes up, click the Setup tab in the upper left hand side of the page:
    ddwrt1.png
  3. When prompted for a User Name and Password  enter: 
    Name:   admin
    Password:  revelrocks 
  4. Near the top of the page under WAN Setup/Wan Connection Type:
    • Change the Connection Type using the drop-down from Automatic Configuration - DHCP  to Static IP:
      ddwrt2.png
    • Enter the WAN IP Address, Subnet Mask, and Gateway information as provided by your ISP:
      ddwrt3.png
    • Scroll to the bottom of the page and click Save
    • Wait a few moments for the screen to reload and then click Apply Settings:
      ddwrt4.png
      ddwrt5.png


Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request
Want to request a new feature? Click here!
Still have questions? Contact our friendly Support team